Installation Guide for (09-18) Dodge RAM 1500 / (10-18) RAM 2500/3500 / *(19-20) RAM 1500 Classic PRO-Series LED Tail lights
THIS GUIDE IS FOR
Do NOT use dielectric or any type of weather sealing grease on connectors or sockets.
Doing so will result in connection problems and will not be covered under warranty. Please click HERE for further explanation.
Table of Contents
Disclaimer: This installation article is a tutorial guide. By reading this article, you agree it is for reference only and AlphaRex USA and its distributors make no guarantee on the finished results. Under no circumstances whatsoever shall AlphaRex USA nor its distributors be liable for any damage, misuse or personal injuries. If you do not fully understand the installation procedure, it is highly recommended that you seek help from professional mechanics to do the installation.
INSTALLATION TOOLS
1/4 Ratchet
Power Tool
Torx Screwdriver
1/4 Extension
Socket
(Star Torx)
Size NEEDED
NOTE: Whenever using a power tool, please make sure do not overtighten the screws.
Whenever working on your vehicle
always make sure your vehicle is parked with the ignition off.
PART I - REMOVE TAIL LIGHTS
UNSCREW TAIL LIGHTS SCREWS
Use T25 Bit screwdriver or power wrench to remove the top and bottom screws.
Please set them aside for later re-installation.
After screws removal, gently pull the tail light outward with a slight angle.
UNPLUG SOCKETS AND REMOVE TAIL LIGHTS
Unplug the sockets before removing the tail lights.
Repeat the same steps for the other side of tail light and remove it completely.
PART II - INSTALL TAIL LIGHTS
NOTE BEFORE INSTALLATION
* For 19-20 Ram, not compatible with 5th Gen new body style models
* For 13-20 Ram with factory LED tail lights requires converters to install
If your vehicle comes equipped with stock LED Tail lights
you would need to purchase optional converter from ALPHAREX.
https://www.alpharexusa.com/product/09-18-ram-truck-pro-series-led-tail-lights-red-smoke
PLUG THE WIRING
Plug the wiring and light sockets directly to the new ALPHAREX tail lights. (if your vehicle comes equipped with stock LED Tail light. First, plug the optional converter then plug into the new ALPHAREX tail lights)
INTALL ALPHAREX TAIL LIGHTS
Reverse the removal process to install the new tail lights into the vehicle.
Tighten the 2 X T25 bit screws for each side of tail light
NOTE: Whenever using a power wrench, please make sure do not overtighten the screws.
COMPLETE INSTALLATION
Congratulations! you have completed the installation for ALPHAREX 09-18 RAM 1500 / 2500 / 3500 PRO-Series LED tail lights.
