Installation Guide for 14-20 Toyota 4Runner Headlights

Warning: This installation article is a tutorial guide. By reading this article, you agree it is for reference and AlphaRex USA nor our distributors make any guarantee on any finished results, nor we held any responsibility for any damage, misuse or personal injuries. If you do not fully understand the installation procedure, we highly recommend you seek help with professional mechanics to do the installation.

Step 1

Remove top plastic cover, mounting tap can be remove by pushing the middle of each tap.

Step 2

Remove the 10mm and the 2 mounting taps on the upper part of the front grill.

Step 3

Remove the 4 mounting taps on the back of the lower part of the front grill.

Step 4

Remove the 6 x 10mm bolts, three on each side by the wheel well.

Step 5

Remove 6 x 10mm bolts on the bottom across the bumper, unplug the passenger side fog light while you are removing the bottom bolts Below image show the 3 bolts on one side, remove the other 3 bolts on the other side.

Step 6

Pull on the side of the bumper, you can use the small flat head screw driver to help release the clips.

Step 7

Loosen the front bumper cover and unplug the driver side fog light and remove the front bumper completely.

Step 8

Lift up both side molding along the fender

Step 9

Remove the 4 bolts that’s holding the headlight.

Step 10

With the headlight remove, unplug the 4 connectors.

Step 11

With both headlights remove, it’s time to connect the DRL harness, with the red to the battery positive, black to the negative or the 10mm bolts on the firewall.

Step 12

In order for the DRL to function during the day, you will need to tap the grey wire into your INJ fuse (10A) route and connect the two red wires, one to the back of each headlight.

Step 13

Transfer bumper bracket from stock headlights to our headlights.

Step 14

You will next aim the headlights at about 25ft against a wall on a level surface. Clockwise – Lower, counterclockwise – Raise.

AlphaRex 2007 2008 2009 2010 2011 2012 2013 Toyota Tundra Sequoia Projector Headlights Installation

You are all set!

Comments(02)

  1. AL February 11, 2020

    I already installed my led lights on my 4 runner That is using INJ fuse 10, how can I use the DRL for the new installment of the AlphaRex Nova ? Is there another fuse or do I connect bothe red wires together??

    1. Nelson Man February 20, 2020

      you can tap in together with your LED lights as these are not using a lot of power , most likely around 1-2 amp only.

Comments are closed.