Installation Guide for 14-21 Toyota Tundra LUXX-Series LED Tail lights
THIS GUIDE IS FOR​
Table of Contents
Disclaimer: This installation article is a tutorial guide. By reading this article, you agree it is for reference only and AlphaRex USA and its distributors make no guarantee on the finished results. Under no circumstances whatsoever shall AlphaRex USA nor its distributors be liable for any damage, misuse or personal injuries. If you do not fully understand the installation procedure, it is highly recommended that you seek help from professional mechanics to do the installation.
INSTALLATION TOOLS
1/4 Ratchet
Torx Screwdriver
1/4 Extension
Socket
(Star Torx)
Size NEEDED
Whenever working on your vehicle
always make sure your vehicle is parked with the ignition off.
PART I - REMOVE TAIL LIGHTS
REMOVE TAIL LIGHTS SCREWS
Open the trunk gate and start by removing the tail light’s screws.
Gently remove the tail lights by pulling outward.
UNPLUG THE SOCKETS AND REMOVE TAIL LIGHTS
To remove the tail light, unplug the light sockets completely
Repeat the same steps for the other side of the tail light for the removal.
PART II - INSTALL TAIL LIGHTS
PLUG THE SOCKETS AND INSTALL TAIL LIGHTS
First, plug the REVERSE light bulb socket directly to the bottom of the new ALPHAREX tail light.
Second, plug the PARKING / BRAKE light socket directly into the new tail lights. Then, plug the TURN SIGNAL light socket at the top.
Please follow the same steps for the other side of the tail light.
After the sockets are plugged into the new ALPHAREX tail lights, reverse the removal process to install the new tail lights into the vehicle.
Use Torx screwdriver to tighten the 2 X T30 screws for each side.
COMPLETE INSTALLATION
Congratulations! You have completed the installation for ALPHAREX 14-21 Toyota Tundra LUXX-Series LED tail lights.
