Article

Installation Guide for 14-21 Toyota Tundra PRO-Series LED Tail lights

img_slogan_242424

THIS GUIDE IS FOR​

ALPHAREX specializes in designing and producing superior and uniquely stylish aftermarket automotive performance lighting with unrival innovative technology. The following installation guide we take you through the installation of your new ALPHAREX TAIL LIGHTS for your 14-21 Toyota Tundra step by step.

Table of Contents

Disclaimer: This installation article is a tutorial guide. By reading this article, you agree it is for reference only and AlphaRex USA and its distributors make no guarantee on the finished results. Under no circumstances whatsoever shall AlphaRex USA nor its distributors be liable for any damage, misuse or personal injuries. If you do not fully understand the installation procedure, it is highly recommended that you seek help from professional mechanics to do the installation.

INSTALLATION TOOLS

1/4 Ratchet
Torx Screwdriver
1/4 Extension
Socket
(Star Torx)
Size NEEDED
No data was found

Whenever working on your vehicle
always make sure your vehicle is parked with the ignition off.

PART I - REMOVE TAIL LIGHTS

REMOVE TAIL LIGHTS SCREWS

Open the trunk gate and start by removing the tail light’s screws.

Use Torx screwdriver to remove the top and bottom T30 screws from each side of the tail lights.

Gently remove the tail lights by pulling outward.

REMOVE THE SOCKETS AND THE TAIL LIGHTS

In order to remove the tail light. First, twist to remove the TURN SIGNAL light bulb socket and remove light bulb. Second, twist to remove the REVERSE light bulb socket and retain the light bulb for later installation. Third, twist to remove the PARKING/ BRAKE light bulb socket and remove the light bulb.

Repeat the same steps for the other side of the tail light for the removal.

PART II - INSTALL TAIL LIGHTS

CONNECT THE SOCKETS AND INSTALL TAIL LIGHTS

First, install the REVERSE light bulb socket directly to the bottom of the new ALPHAREX tail light. Twist clockwise to lock the socket.

Second, plug the PARKING / BRAKE light connector directly into the vehicle’s socket.
Third, plug the TURN SIGNAL light connector directly into the vehicle’s socket.
Make sure to twist (clockwise) and lock the sockets tightly to prevent any dirt/moisture built up.
Please follow the same steps for the other side of the tail light.

After the sockets are connected into the new ALPHAREX tail lights, reverse the removal process to install the new tail lights into the vehicle.

Use Torx screwdriver to tighten the 2 X T30 screws for each side.

COMPLETE INSTALLATION

Congratulations! You have completed the installation for ALPHAREX 14-21 Toyota Tundra PRO-Series LED tail lights.

Shopping cart
Start typing to see products you are looking for.