Installation Guide for 19-22 Chevy Silverado PRO-Series LED Tail lights(FOR VEHICLE EQUIPPED WITH FACTORY LED TAIL LIGHTS)
Table of Contents
Disclaimer: This installation article is a tutorial guide. By reading this article, you agree it is for reference only and AlphaRex USA and its distributors make no guarantee on the finished results. Under no circumstances whatsoever shall AlphaRex USA nor its distributors be liable for any damage, misuse or personal injuries. If you do not fully understand the installation procedure, it is highly recommended that you seek help from professional mechanics to do the installation.
INSTALLATION TOOLS
Pick Tools
1/4 Ratchet
Power Tool
Torx Screwdriver
Pliers
1/4 Extension
Socket
(Star Torx)
Size NEEDED
NOTE: Whenever using a power tool, please make sure do not overtighten the screws.
Whenever working on your vehicle
always make sure your vehicle is parked with the ignition off.
PART I - REMOVE TAIL LIGHTS
REMOVE TAIL LIGHTS SCREWS
Open the trunk gate and start by removing the tail light’s screws.
Remove the top and bottom T15 screws from each side of the tail lights.
Gently remove the tail lights by pulling outward.
UNPLUG AND REMOVE THE TAIL LIGHTS
Unplug the sockets and remove the reverse light bulb from the tail light.
PART II - INSTALL TAIL LIGHTS
PLUG THE ALPHAREX TAPRIOL-Se rLiesIGHTS CONVERTERS
Because your vehicle is equipped with FACTORY LED TAIL LIGHTS, it is necessary to use the
AlphaRex Tail lights converters SKU: ATL-CVT-CL19 (sold separetely).
For purchase or more details please visit www.alpharexusa.com
DO NOT USE DIELECTRIC GREASE!
Prepare your new ALPHAREX Tail lights before installation.
Plug the converters to the new ALPHAREX LED Tail lights.
IMPORTANT: Push the connectors into the sockets firmly with clicks, so they are perfectly tighten and securely contacted. AGAIN, DO NOT USE DIELECTRIC GREASE!
1) Plug the BRAKE LIGHTS connector
Twist and secure the socket tightly
2) Plug the TURN SIGNALS connector
Twist and secure the socket tightly
3) Plug the PARKING LIGHTS connector
Twist and secure the socket tightly
4) Plug the TURN SIGNALS connector
Please follow the same steps for the other side of the tail lights.
Make sure all the connections are plugged and tight. Also the caps are sealed.
INSTALL THE TAIL LIGHTS
First, remove the reverse light bulb from the vehicle. Then, connect the socket to the reverse light
connector from the new ALPHAREX tail light.
Lastly, plug the vehicle’s tail light socket to new ALPHARE tail light connector.
Gently push the tail light into the mounting position and use T15 screwdriver to tighten the top and
bottom screws.
Please repeat the same process for the other side of the tail light.
NOTE: Whenever using a power tool, please make sure do not overtighten the bolts.
COMPLETE INSTALLATION
Congratulations!
you have completed the installation for ALPHAREX 19-22 Chevy Silverado
PRO-Series LED tail lights.
